Mark42
Fleet Admiral
- Joined
- Oct 8, 2003
- Messages
- 9,334
Have been hacking on these cabinets to get them to fit in the corner like I want. Had to cut the back corners off each of the cabinets. The sides and bottom cut straight as an arrow, the backs were made of light weight stuff that bowed under the weight of the saw and I got crappy cuts. Will hide that with new laminate board. Also screwed 1.5 x1.5 ripped form 2x4 and screwed to the wall to support the table top at the edges. This is where the TV and later a large screen TV will go.
Here is the top on the cabinets. Its 3/4 inch ply with birch veneer and 3/4 round oak glued to the edges. Stained same as computer desk, and again, it should match the furniture in the room. My mistake is there is way too much overhang on the far left of the top. Oh well, at this point I'm not going to change it. The front edge of the top is 54 inches across, enougn to fit a large screen TV after I recoup from the expense of the floor and cabinets.
And here is a shot of the desk with the PC in the left cabinet, and the scanner/fax/printer on roll out tray on the right.

Here is the top on the cabinets. Its 3/4 inch ply with birch veneer and 3/4 round oak glued to the edges. Stained same as computer desk, and again, it should match the furniture in the room. My mistake is there is way too much overhang on the far left of the top. Oh well, at this point I'm not going to change it. The front edge of the top is 54 inches across, enougn to fit a large screen TV after I recoup from the expense of the floor and cabinets.

And here is a shot of the desk with the PC in the left cabinet, and the scanner/fax/printer on roll out tray on the right.

Last edited: