Hi All,
I picked up a boat with a 1993 Evenrude 115 this week. I had an inspection done befor paying for it and there was some work that needed to be done on the motor (carbs/water pump/steering)
When dropping off the boat, I asked the tech to check over the oil injection system, figuring why not get that cleaned out, tested and set up to make sure its all working right.
I asked about the oil in the tank, if it was any good since its been sitting, he said it would be fine, however that it is most likely TC W3, and the new stuff is XD30 (or something like this). He suggested we start fresh with the new version, I said go for it...whatever make the motor happy.
Whats the deal with this, does anyone have the story on the change in oil?
Thanks
MS
I picked up a boat with a 1993 Evenrude 115 this week. I had an inspection done befor paying for it and there was some work that needed to be done on the motor (carbs/water pump/steering)
When dropping off the boat, I asked the tech to check over the oil injection system, figuring why not get that cleaned out, tested and set up to make sure its all working right.
I asked about the oil in the tank, if it was any good since its been sitting, he said it would be fine, however that it is most likely TC W3, and the new stuff is XD30 (or something like this). He suggested we start fresh with the new version, I said go for it...whatever make the motor happy.
Whats the deal with this, does anyone have the story on the change in oil?
Thanks
MS