GLM casting flash

[roach502]

Just got a set of new iron manifolds for the 502 today,they look pretty straight but notice quite a bit of casting flash around the mouth of ports.Think i could clean them up with the die cast grinder?I port match the heads and intake, and the machine shop said i did a good job for a firsttime job on a v8 other than porting bikes.THANKS

 

[chiefalen]

Re: GLM casting flash

Hope so been hearing horror stories about glm.

Make sure the mating surfaces are true.

 

[Bondo]

Re: GLM casting flash

Think i could clean them up with the die cast grinder?

Ayuh,...

And a flat File accross the riser flange, to check for Flatnest....