head torque settings for johnson 60 1982

[barry barnes]

Hi

Can anyone tell me the correct head torque settings for the above motor please?

One cylinder is way down on compression and the unit will hardley run. Is a ring replacement likely to fix my problem and can I, a keen novice carry out the work myself.
Thanks
bb

 

[ezeke]

Re: head torque settings for johnson 60 1982

The cylinder head gasket may be blown, so you should take the cylinder head off and check it. The torque setting is 18-20 Ft. Lbs. (24-27 N-m).

 

[HighTrim]

Re: head torque settings for johnson 60 1982

...and be sure to torque them in the proper sequence, a clockwise circular pattern like the following starting in the middle....

9.............10
5.............6
1.............2
4.............3
8.............7

 

[barry barnes]

Re: head torque settings for johnson 60 1982

Thanks
I have removed the head and the gasket is blown on the low compression cylinder i hope the rings are ok. thanks again guys

bb

 

[barry barnes]

Re: head torque settings for johnson 60 1982

Hi
While awaiting the arrival of new gaskets I have been carefuly cleaning the head faces and have noticed a fair amount of compound on the faces and bolt threads. Do i need to use a compound during reasssembly?
Thanks
BB

 

[ezeke]

Re: head torque settings for johnson 60 1982

Wait for the gaskets. Many have a self-sealing finish that will not require a sealer. The important thing will be to have the mating surfaces very clean.

 

[barry barnes]

Re: head torque settings for johnson 60 1982

will do thanks

 

[barry barnes]

Re: head torque settings for johnson 60 1982

Hi
my gaskets arrived at last the casket comes with a bead of sealant on one side.shouldv this side be against the head or the block?

thanks
bb