2001 Suzuki Df70 Code 32 Help

[JIMMY MAC]

Looking For Help With My Df 70. Alarm Beeps And Code 32 Displays Continuously. Any Suggestions Are Appreciated Before I Take Engine To Dealer. Ran Engine Several Miles On 4/27 And Ran Great. After 1/4 Mile No Wake Speed Just Before Docking, Engine Suddenly Shut Off And Was Hard To Restart. I Smelled Fuel And When I Did Get Engine Started It Ran Rough And Alarm And Code Started. I Was Told By The Dealer Where I Buy My Parts It Is A Map Sensor Code. He Suggested Checking Vacuum Hoses Before Bringing Engine To Dealer. I Did Find A Pinched Vacuum Hose And Corrected Pinched Hose But Alarm And Code Continue To Come On After Turning Key On, However I Have Not Started Engine Since Repairing Hose. Must Engine Be Started To Clear Code If This Did Repair The Problem Or Must You Have Code Cleared Another Way ? Thank You To Anyone Considering A Response.

 

[k4ubr]

Re: 2001 Suzuki Df70 Code 32 Help

the code 3-2 is a map sensor, one thing did the motor ever back fire before the code, or is it back firing now.

 

[JIMMY MAC]

Re: 2001 Suzuki Df70 Code 32 Help

No Backfires Or Runnuing Rough Untill I Restarted The Engine After It Shut Off At Low Idle Speed. I Did Get Engine Restarted And It Missed And Chugged Some And I Could Smell Some Unburned Fuel. Towed Boat Home Three Hours And Hooked Up Ear Muffs To Flush Out Salt Water. The Engine Started Fine At Home And Idles And Seems To Run Fine Now However The Alarm Still Beeps And Code 32 Appears Ongoing. Please Note That I Also Had A Code 14 (i Was Told This Was Temperature A Little High But Not Overheating) Recently And I Replaced The Water Pump And Thermostat Before This 1st Trip. I Also Purchased A Temperature Sensor But Had Not Installed It Yet Because I Thought The Water Pump And T-stat Would Correct The 14 Code. I Was Also Getting The 14 Code On This Trip At Times Prior To The 32 Code Incident. Water Pump Is Pumping Very Strong. I Am Going To Install The Sensor Just In Case It Is Bad. I Still Have Not Run Engine Since Correcting Pinced Vacuum Hose. I Wonder If I Should Just Replace The Map Sensor Or Not ? Can I Test Map Sensor ? Any Thoughts On Code 14 Also ? Sorry For So Much Detail But I Thought It Might Help. Thanks For Responding K4UBR ! It Is Appreciated !