Recent content by ‘73BeeCraft

Ok great, thx.

Do I use laminating or finishing resin?

Yeah I thought about that too, extending the deck supports.

I’ve got my measurements. Sketched to lay out. These stringer weren’t bedded really.

No the was blocks of foam running down the center between the stringers. They were just resting in there. Saturated of course. I think I’ll do 2 part foam once I get there.

Floor is completely out. Stringers still in place. For now. This is what it looks like. Idk what’s going on the the center stringer

So I can bed without foam?

So if I bedded the stringer in PB would that be good enough?

Ok so I’m tackling the stringers this weekend. Tab in with CMS, then 1708 then CMS, and 1708 cap?!?!? Is the foam spacers between the hull and stringer a real thing. It seldom gets mentioned?!?!

And one know anything about this boat. Gal wants $2k for it. It been in the garage for the past year.

I have this outboard. It’s a “Chrysler 70”. That’s what the cover says. I assume that means a 70 h/p? Well anyways. I can get it to turn over. But that’s it. Compression is at 92 psi on all three cylinders with good spark and new plugs. I got a new line with fresh gas. 50:1. Battery is new...

Ok. I’ll check it out. New tank?

I will. I’m trying to get the motor to run. I’ve built tables, remodeled bathrooms and landscaped yards. I’ve always been able to avoid small engine repair. Until now. I have good compression 92-94. I have good spark. I got a new tank and mixed up a gallon with 50:1. Nothing. I just it up with...

Yes it has a cradle. I was hoping not to pull the cap. But I may have to pull it anyways.