Recent content by 09231960

  1. 0

    Help with prop 3 blade to 4 blade

    Hello Need some help,I want to try a 4 blade Solas Amita ALuminum propeller on my F225 Yamaha,just not sure what pitch to try,I am running a Stilleto 3 blade 14x21pitch SS now,it runs out at 5900 rpm and 49 mph (gps),the prop is a little beat up so I want to try something else,I am not sure if I...
  2. 0

    Michigan wheel apollo question

    Looking at trying a Michigan apollo 15 1/4x19 pitch SS prop on my F225 yamaha, Anyone have any experience with these props.Are they a bow lifter or stern lifter? My boat is fairly light in the bow so i want to be careful about trying this prop. Any information would be appreciated.
  3. 0

    fitting merc prop to yamaha

    Hello, Wondering if it possible to use a Mercury fixed hub prop on a Yamaha F225 and if so what would I need.
  4. 0

    Solas props

    Hello, Looking for feedback on the HR titan props,looking at the 14 3/4 x 20 pitch prop for my F225 Yamaha vs a 4 blade 19 pitch in stainless merc rev4.
  5. 0

    yamaha f225 alternator pole question

    Hello, Does anyone know how many poles for a yamaha F225 alternator,want to make sure my tach is set properly but need to know the poles. Thank you
  6. 0

    Yamaha Mercury prop question

    Hello, I have a chance to try a Mercury 14 x21 pitch laser prop on my Yamaha F225, The problem is this is a fixed hub prop.Can I use this on my Yamaha? Not sure if I would need a different thrust washer or if I Just should not try it. Splines seem to be the same and of course it is a 4 3/4" hub...
  7. 0

    F225 prop question

    I have a Yamaha F225 on an Alumacraft trophy 200,this is a 20ft aluminum open bow boat.The prop that was recommended to me was a 14 3/4"x21 pitch 3 blade stainless.I get a lot of porposing with this prop after just trimming it up a bit.Prop runs out ok but at top rpms I do have a lot of steering...
  8. 0

    '04 Yamaha F225 RPM question

    I have a Yamaha F225 4 stroke,My Rpm's seem to fluctuate,for example,I run at 32 mph at 3700 rpms with a 14"dia.x 23 pitch prop,the next day I might have to run it at 4000-4100 rpms to get the same speed,I have been trying to get the proper match up with props but now I am wondering if I have an...
See more
Top