Cleaned out high speed orifice and still bogging down with advanced throttle!
Fingers over carb intake resolves problem.
Any takers on this frustration?
Greetings
Took the boat out today after having performed the following:
1. Completely rebuilt carburetor
2. New fuel pump
Engine idles smoothly
Does not appear to be misfiring
Navigating through a no wake zone is problem free
Once out in the clear ...as throttle is advanced RPMs increase but...
Howdy,
Gave my son my 1995 Kawasaki ZXI 750 which was running pefectly.
When he gave it back to me it wouldnt start.
I pulled the plugs and watched clear water come spurting out of the plug holes.
What in the world!!
He never was able to find the time to use it so I know it wasnt rolled over in...
Assistance appreciated
After running for less than twenty minutes at idle gas starts pouring out of carburetor.
Sounds like a stuck needle or improper float level.
Anyone have additional thoughts?
Thanks
Greetings All,
I am restoring 14 ft, 1967 Glasspar Tacoma which has no seating.
I would like to build seats as close to the original configuration as possible.
I don't have any suitable pictures or drawings from which to start.
If anyone has something I could see I would be much obliged.
Thanks...
Help
There is a small hole on the right side of my lower unit located between the top oil fill plug and the low fill plug.
After running the engine and shutting it off a milky oily watery drainage could be seen coming from that hole.
Doesn't seem right. Any thoughts?
Thanks
