My project is a 30x18x24 livewell. The actual water capacity is about 35 gallons. I am going to make this with a foam core and fiberglass. My problem: I can only find polystyrene foam locally and I want to use polyester resin. 2 reasons for this, polyester resin is much cheaper than epoxy and...
I am replacing the shift cable on my Alpha 1. The manual says no more than 2 threads on the retainer nut should be exposed. Is that 2 threads on the forward side (bellows side) sticking out or 2 threads between the retainer nut and the bell housing?
Thank you for taking the time to answer.
Jason
I broke the shift slide while removing my out drive. Are there any tips to removing the slide for replacement? I have the shop manual (number 1)for this drive but I can't find anything on the shift slide.
Anyone have the intake thru hull for their bait tank plumbed through the bottom of the boat? I am trying to figure out the best placement for the thru hull fitting to supply water while I am underway. All my free board and transom is out of water while I am underway (on plane). Any suggestions...
I am getting ready to make a couple jump seat for the stern next to my doghouse. I was going to make these out of 2x4s and then encapsulate the wood. Now I am thinking I may not need to use 2x4s but maybe 1x3s. What do you guys think? Do you think 1x3s would be too weak? Here is a picture of my...
I am looking to buy a radio for offshore use. Probably between San Pedro, CA and Catalina Island about 22 miles or so. Do you guys have any suggestions? The one I am looking at right now is a Cobra MR F75.
Thanks
Jason
I am getting ready to put some paint on the boat. I am painting 2 colors. White on the upper half and blue on the bottom half. Does it matter which color is painted first? The blue and white will be next to each other so I have to cover one with the other at some point. Any thoughts?
Jason
What are the consequences (if any) of changing gear ratios? Mercruiser says that my inline 6 (160) should have a 1.68 gear ratio. What would happen if I changed that to 1.98? Is it purely a performance issue? Is it a reliability issue? I think I understand that prop shaft RPM will drop with the...
1970 L6. Original 1970 transom plate, gimbal housing, gimbal ring, and bell housing. I have read that there may be some difference between an inline and V engines with the transom plate, gimbal housing, gimbal ring, and bell housing. I want to put a newer gimbal housing on my boat so I don't...
Pre Alpha "MR". Which way does the tapered roller bearing come off of the drive shaft? Does it come of the pinion gear end or the pre load pin end?
Jason