FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I have a small very slow leak that leaks from the forward part of where the upper and lower unit meets when it is trimmed up. I not sure if i forgot something when i changed the water pump for the lower unit. Any ideas
I had convinced my self that I had a bad prop seal, but after thinking ab out it I never really had a problem with it until I replaced the lower unit water pump. Could there be something I could have overlooked that would have caused a small amount of oil to pool in the prop carrier area.
I have a 1973 delata tri hul, with a 140hp merc i/0 pre alpha. I just noticed "luckily before i went to the lake" that my prop seal is leaking. I have read the merc. manual and it is not to particular on repair of the prop seal. I know I have to remove the main nut with a special tool, but can i...
Ok so I have a 17ft 1973 Delta Trihull with a Merc 140 I/o. I bought this boat last summer early and had it out 6 or seven times and had a very hard time getting her to plane out. I have tried plenty of stuff but my symptons seem wierd. I am able plane out but only if its me and one other...
I have tried reading most faqs and other posts to try and figure this out on my own but still stumped. I just got this 1973 delta tri hull with a 140hp merc I/O in it. The engine will idle very well and has decent to good power at low rpms <1700. The problem is when i put the hammer down it doe...
