Thanks again for all your help. Got the ring in, and the exhaust bellows was a bit difficult. All done that part, now off to hook the cable up and adjust.
Thanks again,
Ken
Thanks for all the replies!
Tried the that but the ring seems to get hung up on the leading edge of the bellow. Got a couple hours of trying to get past it to no avail.
Hey guys. Hope everyone is having a good holiday season, so far.
Took the bell housing off, changed all the bellows, water hose and drive oil line.
Cannot get that ring on the u-joint bellows in. Is bellows adhesive required at that location. I made a tool to drive it in, but i suspect i will...
Thanks Chris. Hit the nail right on the head.
There is a bit of water sitting in there and I'm a little concerned it may freeze. I put the drive on so I could run it for oil change, so it has to stay out side now. Had the drive blasted last year, so I'm wondering if that may have hardened in there.
Hey people, been a while. Just got my drive all serviced and ready to go. Last year my speedo was not working so I thought I would fix that this year.
I can't force air through pick up in the lower drive from either direction. I cleared the passage from the bottom with a drill bit by hand and...
Asking for a friend.
He froze his 5.0L and moved most of the bolt ons to a 5.7L short block including the intake and 2 barrel carb. I have a 4 barrel Carter, which was on my 5.7L which we would like to put on his 5.7L. What would we need to accomplish this and would it be worth the effort...
Well I don't know if anybody other than Ted cares about my little adventure, but I will share my progress anyway.
I used a chemical stripper and it got most of the many layers of paint off. I then used a brass wire wheel to take the remainder of the material off. I know your not supposed to use...
Went to the paint store to pick their brains about painting my out drive. They recommended this stuff. Also he said i will need to strip all the pain off with this stripper he recommended. He also said both products were safe on aluminum. This is a re branded version of Por15, if you guys are...
