Recent content by 1990 looper

  1. 1

    Viper 14.75 x 19 comps

    Hi, Ranger Boats recommended a Viper 14.75 x 19 for my boat and motor set up. I have a 1990 690c with a 140 Evinrude. They obviously recommend what they are told by BRP. So, I was hoping you might be able to enlighten me on what might compare equally? Such as Solas, Mich Wheel, Merc... Thank...
  2. 1

    Prop suggestions on a 140 looper

    Hi, My 140 is running great and have only run test in a barrel. Hopefully this weekend I can get on the lake and do some WOT and etc. The engine currently has a slightly dinged alum prop. There seems to be a large selection of used SS props out this for these motors. I recently found a 14,25...
  3. 1

    140 Looper REED BOX gasket failure

    Hi, I finally found the carb spitting and sputtering problem with my ol'looper and still have some questions. The gaskets that sandwich between the reed cage and intake plate failed. It looks like they were weak from fuel. Plus OMC only used two screws to fasten the box. One screw on each end...
  4. 1

    Fuel before throttle plate?

    Hi, I have been restoring a 1990 140 looper. It has been running extremely rich and I assumed it was an ignition problem. More recently I was running it with the air box off. Never did that before. Well, I may have found the problem. Left bank carbs were trickling quite a bit of fuel prior to...
  5. 1

    1990 140 Evinrude photos - Help?

    I need help with finding some good photos of a stock 1990 140hp Evinrude. I need to have a custom set of decals made and do not have anything to email. My covers are primed up and ready for color. I'm considering leaving most of the graphics off except for the rude decals.. But, I'm not sure...
See more
Top