Must replace the primer fogging valve, gasket, and cover ? pic attached. Anyone, know how much the cover screws must be torqued down? I don?t want to break the puppy George. Many Thanks..
I see reference in the forum to ? x 20 and 5/16 x24 flywheel removal bolts. These are the three bolts that are used to connect the puller to the flywheel. The OE manual references puller P/N 378103 with three screws P/N 309492. Anyone know which size screws/bolts are needed to connect the...
1995 J200 V6 - Was unable to prime fuel after the boat sat for seven months and a fuel/water separator change. Pumped the bulb many times with no indication of fuel flow. I removed the fuel line that enters the in-line fuel filter near the motor and was able to prime fuel into a catch bottle...
A bit wordy but descriptive.. 1996 Wellcraft Excel (Coastal 23) Electric gauge at the console shows empty, but the mechanical gauge at the tank is accurate. I have a swingarm mechanical type of sending unit in a 99 gal gas tank. The unit has an electronic 'capsule' that shows the fuel level at...
Have a 1995 200hp Johnson Oceanrunner. Motor sometimes quits while idling (700rpm). Motor often quits when placed in gear and throttle advanced past idle around 1500 rpm. The motor was rebuilt in 2005, and last year replaced the power pack rebuilt carbs with oem kits. When the motor stalls it...
Have a 1995 Wellcraft Coastal 23 and 1995 Johnson OceanRunner. Boats past due for shift and throttle cable replacement. I am not sure how long the replacement cables should be and really want to be certain of required length before ordering them in spring. Is there a way to determine...
Am considering a wreck anchor made of pliable rebar to use on wrecks and rocks. I figure there?s a greater chance of getting the chain hung up if there?s more of it down there. The rebar anchor will bend when pulled hard enough, but if the chain gets caught then it bye bye anchor, chain, and a...
Have a 1995 J200 OceanRunner and want to switch from standard TC-W3 to a blend or full synthetic oil to lessen smoke and carbon buildup. Is it ok to mix the two in the oil tank? Should the dino oil be ran down to a ? tank or so before adding the synthetic? Any issues switching back to standard...
Hello all. I am a newbie to iboats. Found some great advice on this web site from other peoples posts. My problem description may be a bit wordy, but I guess more details may offer more clues to the source of the problem.
I have a 1995 23? Wellcraft Coastal with a Johnson 200 OceanPro with...
