New top and interior. Ran like a dream for a few years. Now I’m having problems after it worms up. Starts running rough then dies. Coil gets hot like a firecracker. I think my aftermarket electronic ignition module is bad. Nothing else checks out. New coil didn’t do anything.
I wanted to find an all inclusive distributor and do away with external coil. Want electronic ignition with it of coarse. $450 is about the cheapest I can find. Any ideas where to find one cheaper?
1966 mercruiser 153ci 2.5L
I have what I believe is a 1959 fat 50. Model V4S-11. Serial number 1831512. Just got it out of a barn sitting probably 25-35 years. It’s sitting on a Fleetform boat.
Anyway it spins great with its electric start but has no spark. There is a single wire going into the distributor which has what...
I have a 1966 Larson with 120hp mercruiser stern drive. The out drive leaks down over an hour (give or take). No visible external oil leaks anywhere. This is a single line ram and only designed as tilt. No trim. Any ideas on cause?
I had a boat shop working on my old larson for several years during his "spare" time. I got the boat back last month with the enging half wired. I have a repair manual but it doesn't tell me the color of the wire for the temperature sending unit, or the tachometer for that matter. Does anyone...
I'm having the hardest time finding a windshield for my '65 Larson All American. Anybody know who makes replacements?
This is a wrap around with a front that bubbles out.
Taylor Made only sells flat front windshields
Hey guys. I was getting ready to put my lower unit back on after reversing my clutchdog and putting in new seals. I noticed on top of the water pump where the drive shaft comes up, there is a spongy looking seal(?) around the drive shaft. It's intact, but doesn't look too good. Is that something...
I have a friend in Dallas that wants to know of a good repairman or shop in Dallas to take his '94 Johnson into for work.
Anyone have a good suggestion?
I tried to look this up and I think it's a 1965. Does this sound right.
A guy on craigslist want to sell this for $250. There is a small(2inch) chunk of fin off the side of the lower unit. Will this make a big difference?
SR # 1771929