I got them apart with a torch and tje pliers from amazon. they were strong but I am still looking for the top of one of the valves . When it came off it flew, I know it is on my deck somewhere. LOL kind of like circlips or as I call them ""By jesus" clips. LOL
Thanks! I just ordered from amazon. I tried my panel clip remover pry bar and almost damaged the check valve in my vice. it got scratched but I was able to buff it out. I think the panel clip pliers will work better. And I will use my propane torch as well.
What is the tool shown in the FAQ being used to take the valves apart? It looks like a valve spring compressor but much smaller.
It took me a bit to get the valves out of the pump body. it took 150lbs of air a rubber nozzle and blocking off every port. that removed one of the vales and the...
Yeah! mine has none of that mechanism The bolt holes are there to install it. That is what I get for a $200 motor 4 years ago. It has always started first turn of the key, and 150 psi compression. LOL
Thanks!
# 4 is what I am making, part no 45 might be more of what I can use. I will order it, but I will continue making part no.4 I just need to know how far apart the two prongs on the port side are. this is the part they want between $100 and 180 IBoats wants $180.
Mine has the circlip style.
On another T@T question .
Where does the trailer lock go? I assume it fits in one of the manual tilt holes but it has two rods on one side.
I am building one because I can't see paying $180 for a 5/16" rod. Every other OB I have owned has had a flip down at the...
Thanks, I will Pm you later I have to put my old t@T pump back on so I can hit the lake this weekend and make sure my new stator from CDI works but that is another story. LOL
I agree a cheap China clone. I am going to return the "new" one. The seller was asking for information that according to Jerry and my own investigation does not exist. Thank you.
Thanks Jerry, I am going to rebuild.
This is probably an ignorant question but exactly where are these seals located are they under the hex bolts or behind the ports.
I have watched your videos several times but I am unsure of their location. I do not mind the brutality. I was going to rebuild...
I HAVE A 1989 FORCE 85 hp MODEL NO. 856A9A, I am trying to fix the tilt/trim system. The original problem was that it leaked down. after a couple of minutes. but it went up and down easily. I bought a new pump assembly from Ebay and it will not go up past the full trim up. position. with my...
I took off my carbs to clean them and found that they did not have a carb bowl gasket on any of the carbs. What are they made of cork or a rubber O-ring? It is part f in the diagram they were also missing part D.
I ordered 3 rebuild kits but they were damaged in shipment and sent back to the...
