Hello, Am planning to remove the oil pressure sender and use a mechanical gauge to test the oil pressure. Looking for data on the thread size for the adapter I will need. Thanks in advance for your assistance.
The original grease fitting ball is buggered up and rusted. I have a SS replacement fitting. Looking for tips on removing, I'm thinking some Kroil to soak, then some heat and then using a grease fitting removal combination tool with its wrench and extractor and tap if needed. Thanks in advance...
Hello, I'm looking for the above for a 1971 Thunderbird Comanche and not finding much luck. TIA for any you can provide especially if you have used them in the past.
Hi JB. White elephant located and enroute. Its been a bit of search but I did find an 8 page Thunderbird catalog that I'll have in hand soon from ebay that I can post as a sticky. Is there a way to do that here or just better to put on the Fiberglassics site.
Need advice on where the mount and the red leads, look like 8 gauge should be connected to as I don't see any thing that appears wired around on my Thunderbird Comanche. I finally found one and want to install it before hitting the water.
The original grease fitting is buggered up and rusted. I have an SS replacement. Looking for tips on removing, I'm thinking some Kroil to soak, then some heat and then using a grease fitting removal combination tool with its wrench and extractor and tap if needed.
Hi Jim, In Ohio, it can be registered as a home built or even by brand without a VIN or titled. The feature that makes it unique is the use of spade 3/4" spade bolts for bunk and roller support as pictured hence I thought one of the seasoned sailors here might recognize the brand. I'm...
Good morning. Am trying to identify the manufacturer of this tubular, welded, tandem trailer I purchased via bill of sale here in Ohio. It uses 3/4" spade bolts to support both the rollers and bunks. I've blasted the 13" wheels and will be painting them next. Thanks in advance for your help...
Good morning. Isolated the small drip to one of the four equal length external braided lines and purchased a factory replacement and a 3/8 hex line wrench. The drive is in the full down position. Is this under pressure when down or can I just put a bucket underneath to catch any drips while i...
Any advantage to installing a block heater for those transitional times when you still want to be on the water in a dock kept boat but the nights can drop into the thirties? Has anyone done this and was it worthwhile in your opinion? Thanks in advance for your input.
Am getting a drip when using tilt/trim. Looks like it might be within the braided hose at the cylinder end or loose fitting. Should I try tightening with line wrench or just replace? Age unknown. Thanks in advance for your recommendation.
