2 stroke maybe 2002 trl model...it runs for a an hour or two running crab traps then will sputter and die ....wont restart til it cools down.Do you think this is the ecm or a coil getting hot and causing the ecm to do this...
Picked it up recently,but the ID sticker is missing.Can it be identified by components? Its a 2 stroke,3 cylinder without oil injection.....I also need to figure out where the positive battery cable gets connected to on the engine.How do I make these pics bigger?
Took my boat out to test motor 40hp evinrude in real condition,still overheating and rpm's limited.unhooked the tan wire to sensor in head and alarm stopped,but rpm's were still limited. Would this be proper operation or should the rpm limiter be overridden by disconnecting the wire also.Not...
My 1984 evinrude 40 hp has approx.100-105 psi in the top cylinder and approx. 80-85 psi in the lower cylinder. Although not optimal,should this be enough to run ? It starts and runs , but seems to be running on one cylinder. Both cylinders are getting spark and when i spray carb cleaner in the...
Picked up a 1984 Evinrude 40ELCR thats less than 100 units off from the same motor I have on my 16ft sabre center console .It appeared to be in better condition than the one I have so I swapped it out on the boat last weekend.I hooked everything up and it started right up,but no water out the...
Recently picked up a pretty clean 1987 long shaft Johnson 9.9 with electric start for use on my C-Hawk 22 sport cabin as a trolling/auxillary motor.Before I bought it I checked the compression 100-110 on both cylinders and started it up...........ran terrible,but I figured it was a dirty carb...
I recently bought a C HAWK 22 sport cabin and want to add a kicker outboard.I picked up a Fulton adjustable bracket off Craigslist locally and want to install my 8hp Evinrude on it.My question is do I really need to have the cavitation plate level with the bottom of the hull or can I mount it a...
I recently bought a C HAWK 22 sport cabin and want to add a kicker outboard.I picked up a Fulton adjustable bracket off Craigslist locally and want to install my 8hp Evinrude on it.My question is do I really need to have the cavitation plate level with the bottom of the hull or can I mount it a...
Just bought a 1988 C HAWK 22 with a 1988 Johnson 140 with VRO,thinking about disconnecting the oil pump/tank and running premix in 12 gallon tanks as the built in tank leaks. What do I need to do ?Any suggestions would be appreciated.
Just picked up this 1988 C HAWK .Its going to need a new fuel tank installed,but for now I'm going to run it on 12 gallon portable tanks.What I want to do for now is replace the seat pedestals with a wood/fiberglass base that I can also store the batteries in as there is no existing battery...
