Recent content by 72Glastron

  1. 7

    1993 Yammie 115... Primerbulb needed?

    installed my new inboard tanks today.... was just wondering if a primer bulb would be needed? I ran it for a bit and it seemed to suck the primer bulb in some. thanks!! :)
  2. 7

    93 Yamaha 115 install on older boat!!

    Ok, heres the deal, I got a great deal on a 1993 Yamaha 115, without controls. Then I found a set of controls (craigslist) that went to a yamaha 70 and bought them. 10 pin connector is working and motor runs!! here is my question. there was two wires with the harness that looks like it...
  3. 7

    slow response 50

    just got my hands on an evinrude 50, 1988 year model. it is attached to a 1988 16ft Polar Kraft Flat bottom. First time out, engine has rough idle and upon WOT it slowly starts to gain engine RPM. I checked WOT and the butterflys are fully open, has fresh gas/mixture, new...
  4. 7

    ignition and charging problems

    I have 1972 Johnson 85hp with Points, CDI Powerpack (non tach wire), CDI coil V-4. Recently this season, I ran into a major missfire situation that I was able to cure by cleaning the Distributor contact areas and the rotor contact area. Afterwards it ran great untill yesterday it starting...
See more
Top