have a 1985 140hp mercruiser 4cyl it runs good except when you give it full throttle at idle. It hesitates then opens up and runs great it is enough make you lunge forward then back . At any other throttle position it doesnt do this any ideas thanks
i have a 1985 140 hp meruicuser 4 cyl with alpha i outdrive purchased the service manual still dont understand water sysem it talkes of closed system which i think i have no radaitor cap but then they talk about antifrez and sea water systems my understanding i have a impeller in stern drive...
recently bought a deck boat with a single axel trailer it has disk brakes operated off trailer hitch there operated off elect hookup for trailer i have never seen this system seems to work good has had any exp with this system thanks
iv got a 1985 mercruiser alpha1 on a 16' huricane deck boat has a 19 pitch ss prop doest do to bad the guy i bought it from says it will do better with a 17" pitch would this gain power or speed
I just purchased a deck boat with a 4 cyl mercruiser 140 hp alpha 1 outdrive it really runs good but blower seems to run most of time is this normal havnt had chance to get manuals on it yet to study up just what does blower do thanks for any help
1975 85hp evinrude rebuilt carbs and runs really well now after setting in driveway notice small amount fule around checked all lines seem tight could fule be comming from carb floats set to high
i just rebuilt carbs on my 1975 85hp evinrude modle 85593 ran great on muffs took it to lake ran ok went to wot right up to speed now wont idle back down and wont start without help and runs about half throttle where did i go wrong
have a 1975 85hp evinrude it is running good and stays cool alot of water leakage around lower unit i just put in new impeller some mist at upper exaust ports ive read on earler posts about some gasket not being in line but not to worry any idea what it is
ive got a 1972 lund trihull nice old boat single axel trailor get it half way on and takes all i got to crank it on up im thinking there might be some rooler adjustment any idea would help