Recent content by 79larson

  1. 7

    water in hull?

    hi ive have a 78 23' Larson, i have noticed that the boat leans a bit with no one in the boat, the gas tank is in the center of the boat, has a v8 and omc 800 o/d, i dont notice any water in the bilge, no holes in the bottom, it did have a small rotted floorboard that i replaced, couldnt see any...
  2. 7

    OMC tilt clutch housing seal

    i am putting new seals in the clutch housing, the seal that is next to the spur gear is thicker in width than the one i took out, it fits the housing diameter wize, just wondering for those have replaced this seal, are the NEW one suppose to be this way? thanks
  3. 7

    omc tilt problem

    79 omc 800 stringer tilt problem, out drive will not come down, i have the tilt motor off, hammerblow coupler out, clutch pack case off,full of water, shouldnt i be able to push the outdrive down, it seems like its jammed, oh and i stood on the outdrive while we hit the down button, it still...
  4. 7

    idle rpm

    have a 350 with a quadrajet, what do you like to have the idle set at in neutral, currently i do not have the esa module hooked up and have it set about 900 rpm
  5. 7

    omc sea water pump

    i have a 79 larson with a 800 series outdrive #982413/W212676, my question is when i hook up the muffs and start the motor i should see the tattle tale stream correct? i do not........ i did run the motor a little with the flush adaptor so i know that i filled the motor and hoses, still no water...
  6. 7

    omc starter question

    i have a 79 larson, that i got with no motor, i have installed a new chev v8, im am looking for info on the wiring on the starter...ive got the large lug that has a large red, and a large yellow/red and a large wire direct to the battery switch,,,,,,,, where does the smaller yellow red and the...
  7. 7

    kodiak exhaust manifolds

    any one use the kodiak brand manifolds, ive got a chev 350, and a omc 800 oudrive, my question is,,,,is they claim that that are very good at not alowing water to get into the motor thru the outdrive, i ask this because, ive got an exhaust flapper missing, and cant seem to find a replacement(...
  8. 7

    omc exhaust flappers

    ive got a 79 larson with a omc 800 sterndrive the model # is982413 serial#w212676, ive got an exhaust flapper that is broke, on the starboard side, i haven been able to find them in any schematics,( cant find my serial# either) and two other parts dealers have not been able to find them, any...
  9. 7

    hei distributor on a I/O

    is it ok to run a gm hei distributor on a inboard outboard to eliminate the original points type distributor, thanks mike
  10. 7

    350 omc pics/ schematics

    hi im new and inherited a 79 larson 23' admiral day cruiser(with no motor) and a 800 series stringer.i now have a marine motor built for me, im looking for pics or scematics that show how the belts/ silinoids etc are positioned on the motor, i have the clymers book on the out drive and have...
See more
Top