Recent content by 95starcraft

  1. 9

    97 Evinrude 150 Rebuild Project

    I just wanted to put this out there. I have completed my 150 rebuild project and I hooked the muffs up and guess what, it fired right up. Running good so far have not yet put it to the test in the water but hopefully this weekend. I just had to get this out I am very excited. Thanks to all...
  2. 9

    Lower Unit Thrust Bearing

    Does anybody know if evinrude replace the part number 126402 with 126807 thrust bearing, I need to order one but I am not sure on which to order the 126402 has a lip and the 126807 appears to tapper with no lip.
  3. 9

    Battery Diodes

    Has anybody heard of TNT Power, I had one on my boat when I bought it, it is a one way diode setup between the starter and deeps it allows the starter to pull juice to off the deeps so juice is always there to start the engine and run accessories. I checked the one way diode with a volt meter...
  4. 9

    Cleaning the Aluminum Boat

    I would like to remove the yellowish scum and grime of my aluminum hull. What is a good safe product to do so. Thanks
  5. 9

    97 150 Fuel Problem

    Can fuel leak from around the intake gasket. I pump the fuel up and it gets hard then I notice a fuel leak around the carbs on the starter side only,could the gasket between the intake and carbs not be seated properly allowing fruel to leak or could it be that floats are stuck. I just can't...
  6. 9

    Prop is binding somewhere

    On my 150, i put the prop on it today, however it feel like it rubs somewhere, with the prop off the shaft turn smooth, could i be missing a bushing somewhere, I only had the brass bushing, nut, and nut cap w/ cotter pin that goes on the end of the shaft. Is there a rubber bushing between the...
  7. 9

    97 Evinrude Gas Leak

    When I pumped up the gas primer the pump became hard and then I noticed some gas leaking around the oil line that connects to the bottom of the VRO, and also on the starter side the carbs are leaking, I am wondering that when I put on the new rubber gasket if that didn't seat properly and gas is...
  8. 9

    Evinrude 97 150 Tilt/Trim Electrical

    Ok so I need to figure out why my trim/tilt won't work, I have voltage going to the relay bracket and can bypass the one relay at a time having to leave one in and make it go up or down but will both in it won't do jack, so I know the wiring up the relay bracket on both side are grounded and not...
  9. 9

    Swap out a Force 90 to a 115 Mercury same year

    I would like to replace my 1994/5 90hp Force Outboard to a Mercury outboard, would I also have to change the controls and possibly anything else to make that work or are the controls the same for those years. The Mercury I was looking at was a 1995 115hp. What do you think a you think a good...
See more
Top