Recent content by 9675hpforce

  1. 9

    poor idle,engine miss,could my timming need adj?

    Could i adj the timming without any tools to see if it would run better.
  2. 9

    Seems li e my motor has a miss

    Sounds electrical under the hood any ideas how to chec and replace parts. i noticed at high rpm around 5,000 it goes up and down,even at idle it has a miss.
  3. 9

    Report my 2003 riptide minn ota autopilot,copilot is wunderbar

    I love that dang setup, people wonder how I control the boat, its magic.
  4. 9

    Adjusting carb screw

    i have only one carb on this year motor. Is the adj screw only for idle? Is the high speed non adj jet?
  5. 9

    Could i run my engine at lake and adj timming

    Without tools? I would like to play with the timming while its running to see if she will idle more smoothly.
  6. 9

    mercury by force seems to have a miss when running?

    Almost seems like an arc miss somewhere. Running at 4400rpm she will drop a little then pic up. Dont think its the fuel bulb.
  7. 9

    purchased Restore 2cycle power improver its blue

    Anyone tried this before and did it help. What is sea foam like wd40?
  8. 9

    Do they make a Restore outboard oil 2 cycle

    Does this work my comps are 107,107,105 cold
  9. 9

    Wanting to hook up the start up warning sounder thingy

    My Starcraft fishmaster with quicksilver merc 3000 controls seems loaded but would like to get the horn working.
  10. 9

    Prop selection I forgot rpm drops

    I have a 11 pitch hustler that helps my engine go faster and pull great but would like a little more top end speed. Wot its around 5,000 maybe a little more. How much drop would an 12 or 13 be.
  11. 9

    How do I hook up the beep beep thingy when starting engine

    Right now there is no warning sound when the engine is started. My controls are the newer Mercury quicksilver 3000. Why no buzz
  12. 9

    Sometimes waterflow then other times not

    I replaced the water impeller last year and the old one was fine so I suspect this one is good to. When I started her up for the first time on muffs she worked great and I took the thermo apart to clean out and now at idle there are a couple drops out the pee hole. When I get on the gas water...
  13. 9

    Which direction does the Thermostat go in?

    Its for a 1996 75hp force/bymercury. I took it apart again today to flush the engine while running hope thats ok. Before I disasembled there was good water flow out the pee hole. Now while idle no water comes out,impeller is in good shape. Where could the water be going in the cyl? How does...
  14. 9

    How to check if head gasket is blown?

    Could a small amount of water be getting into the cylinders. The plugs did show some signes of rust and major fouling. Not a clean plug at all. Any other places water could get into the engine some gaskets or something exhaust,case.
  15. 9

    Where to check for vaccum leaks,exhaust and such

    My force has been running ruff I purchased some new autolight plugs which have alot more electrode than champs hopefully this will help. But at the same time I want to checkout for any vaccum leaks including head. There is a air sound when running without the cover on. Is this just air going...
See more
Top