Recent content by 98BajaOutlaw

I saw that but when I talked to them they recommended this one. Has an o2 sensor in one manifold with an aftermarket cooling setup so the water doesn’t come anywhere near the sensor

Yes

It is an I/O 7.4L 454 Merc

Hi everybody! I recently installed a Holley terminator fuel injection system on my 98 Baja. I am looking for some help dialing in the numbers and adjustments on the system as I can't seem to figure it out. Background on the engine, it was a 200 hour boat but about a year ago I had the engine...

Hi everybody! I recently installed a Holley terminator fuel injection system on my 98 Baja. I am looking for some help dialing in the numbers and adjustments on the system as I can't seem to figure it out. Background on the engine, it was a 200 hour boat but about a year ago I had the engine...

Oh that one I see, after checking the v at all the wires off of the safety switch and ignition I found that there is a break in power somewhere on the purple wire between the ignition and where it meets the coil and alternator. Instead of searching I ran a new wire and the boat is starting again!

Does the terminal wire come from the ignition to the coil pack then to the starter?

It has a holly fuel injected carb on it now. Where would there be a kill switch

Hi everyone, I have a 98 Baja outlaw 7.4L merc. Everything was working fine and now it will not fire. Engine turns over great. Good fuel pressure New starter New coil I have good voltage at the ignition/ safety switch. I swapped a circuit breaker so it’s not that. Any help is appreciated.

Ok

Ended up being one of the power wires touching the neg post. Thanks so much for your help! Happy boating.

1998 Baja Outlaw with a 7.4 Merc 454 I installed a new starter as I burned my old one out, everything was all good, I cranked it for about 3-4 seconds and then it stopped cranking and the starter kept turning until I turned the battery switch off. The power and ignition wire are not touching on...