Recent content by acammelleri

  1. A

    front motor mount for inline 6 chevy

    I have replaced the block with a new and cannot figure out the the right side of the motor mount. The left side is fine there is not a bracket on the other side to attach. Can anyone find a diagram of how this is supposed to be attached. I have looked all over the internet and in the manual...
  2. A

    Distributor problem????

    Bought a rebuilt distributer for my 1976 seastar w/250 straight 6 motor. This was purchased at a local auto parts store. Low and behold it fit and worked but was unaware of the marine rated distributors. So we went out and bought a "marine rated" points and condenser rebuild kit and the bracket...
  3. A

    distributor problems?????????

    Bought a rebuilt distributer for my 1976 seastar w/250 straight 6 motor. This was purchased at a local auto parts store. Low and behold it fit and worked but was unaware of the marine rated distributors. So we went out and bought a "marine rated" points and condenser rebuild kit and the bracket...
  4. A

    ski pylon ideas

    anyone have any suggesstions or ideas on a diy ski pylon. Looking to add one to a i/o 18ft. seacraft. Basic quetion would be where to mount or place so its not in the way of cowel cover of engine compartment thx.
  5. A

    pulling the outdrive

    Should I pull the outdrive before i put a new block in and how in the hell do you get the bolts to line up for the motor.<br /><br /> :mad:
See more
Top