Recent content by Acamper88

  1. A

    Restoring 1988 19’ bayliner capri

    Okay, sounds good. Thanks guys I’ll give that a try later
  2. A

    Restoring 1988 19’ bayliner capri

    Might be a stupid question but the laminating resin I got dries tack free evidently. I didn’t even notice but it says it dries tack free without the need for wax which is my bad for not paying attention. But I already have the new transom covered in the resin. So I know I need to sand it, my...
  3. A

    Restoring 1988 19’ bayliner capri

    Okay, lol sounds like I have more sanding to do than I thought then. Thank you for the info
  4. A

    Restoring 1988 19’ bayliner capri

    Howdy guys, sorry it’s been a while. Weather hasn’t been cooperating lately until the last few days. I’ve made a bit of progress. Got the transom cut out along with the foam removed from the rear. Today I was sanding around the transom area and got to the bottom and found wood in these bottom...
  5. A

    Restoring 1988 19’ bayliner capri

    Would you have still lifted yours off the boat if the bunks were under your stringers or is that even more reason to do so?
  6. A

    Restoring 1988 19’ bayliner capri

    Well I worked on getting some of the foam out after work today for a little over an hour and feel like I made pretty good progress, probably won’t touch it again until this weekend because there is supposed to be some rain coming tomorrow and Thursday. Have a little more cutting to do, need to...
  7. A

    Restoring 1988 19’ bayliner capri

    Okay sounds good, I was just looking through your restoration. Yours turned out really good. How much resin did you end up going through?
  8. A

    Restoring 1988 19’ bayliner capri

    Okay, thank you those pictures are very helpful. I suppose just letting it rest on the bunks after taking the stringers out would deform the hull?
  9. A

    Restoring 1988 19’ bayliner capri

    How did you end up doing the drain for the poor, did you just put in a brass tube?
  10. A

    Restoring 1988 19’ bayliner capri

    That’s not a bad idea. I might go that route instead
  11. A

    Restoring 1988 19’ bayliner capri

    Yeah mine Yeah mine has the small transom too, so thank you I’ll have to do some thinking about that
  12. A

    Restoring 1988 19’ bayliner capri

    The engine is good, and I’ve seen a little about the seacast. How much did you end up needing? Did you do stringers that way too? I planned on redoing the transom using woodonglass’s repair sheets I’ve seen on here. And then I’ve seen where people have cut the top cap of the stringers off and...
  13. A

    Restoring 1988 19’ bayliner capri

    Didn’t get a whole lot done this weekend, ended up helping a buddy move. I did get the 2 seat boxes out behind the consoles, and the rear seat boxes as well. Is there any recommendation on a better way to get the foam out though. I think I spent most of my time getting foam out of the way to...
  14. A

    Restoring 1988 19’ bayliner capri

    Okay, it’s been kinda cruddy weather this week so I haven’t gotten a chance to work on it. But today I’m going to go out and get the seats off, so thank you for the advise, and a little bit more demo in the floor. Then later tonight I will be getting my engine hoist so I can pull the engine off...
  15. A

    Restoring 1988 19’ bayliner capri

    Hi all, I’m looking for some help and guidance. I just purchased a my first project boat. Got it for pretty cheap knowing it was gonna need a bit of work. I’ve started to tear out the flooring and removed some of the boxes so far. The transom, stringers and floor all need replaced. I’ve been...
See more
Top