ok first things first, motor is a 69 johnson 115-hydro electric shift, had this problem along with others in past few years, boat macanic told me to take the wire of the nutral safty switch and hook it up to ground to bypass it. also just ran test and it says that the ign. safty switch is...
on the crankcase head will that bearing seal not being seated all the way cause my baseplate to stick because of escaping exaust fumes? i tapped it down with a large socket and got it to seat about 1/8 inch i hope that this stops my binding problem!
on a previous thread i had explained how my advance arm would bind up only at operating temp. i got some great help and good answers to my questions. i tried bending up on the s clamps that hold down the nylon ring,didnt work,aslo tryed shim washers again it didnt work. so i did some...
i am having problems fine tunning my trottle cable. the motor is all synced with timing and carbs but my book does not explane how to fine toon the throtrle cable.
how much water should come out of the 2 ports on the back of a 69 115 jonhson? because i had just replaced the waterpump and it just barlly spits water out of them. cause for consern?
i have a 1969 johnson 115, and when the motar heats up to opperating temp. when you push the trottle wide open the distributir advance arm does not advance. i have pulled the flyweel and replaced the wearable nylon ring on the distributir base plate,coated it in 2 stroke oil. i have also...
