I have a 2000 50HP Evinrude model #E50PL4EE (4 stroke) the check engine light comes on. I took it to a marine mechanic who hooked it up to the diagnostic computer and it gave really screwed up numbers on the printout as far as engine data. They said I would need a new ECM computer which is...
I have a 2000 50HP Evinrude the check engine light comes on. I took it to a marine mechanic who hooked it up to the diagnostic computer and it gave really screwed up numbers on the printout as far as engine data. They said I would need a new ECM computer which is 1,000-1,300 dollars. The motor...
My check engine lights activates after running the motor about 10-15mins. New water pump installed and the thermostat is operating when tested. If I take the T-stat out the check engine light comes on in about 3mins. When its in 10-15mins running about 6,000 rpm. The head of the motor where the...
My check engine lights activates after running the motor about 10-15mins. New water pump installed and the thermostat is operating when tested. If I take the T-stat out the check engine light comes on in about 3mins. When its in 10-15mins running about 6,000 rpm. The head of the motor where the...
I have a 2000 evinrude 50hp. I hook it up to the garden hose with ears and run it for 15 mins and the check engine light comes on. I had a new water pump impeller installed and the thermostat is opening and closing properly. However the cover that goes over the thermostat gets very hot you can...
I have a 2000 evinrude 50hp 4 stroke electronic fuel injected. I make a bad mistake today. I took my boat out and did not realize that I left the motor flushing ears on the intake of the motor. I started the motor and it was pumping water so when I went to accelerate I only had a 1/4 throttle...
I have a 2000 model polar kraft skiff fiberglass. My question is how to I get the fuel tank out if I have a leak or problem with it. The tank is located beneath the hull with only two inspection holes to view the fuel line connections and gauge. I am not familar with these tanks and maybe they...
I have a 1985 Johnson 25HP I would like to put electric start on it. I have the option to buy a 1990-1991 scrap engine with electric start. My question is will the electric start kit off the 90-91 model work on my 1985 model. Thanks for your help.
I have a 1985 25hp johnson outboard engine. I also have access to a 1958 johnson 25hp with electric start. I was wondering if the electric start kit on the 1958 model would fit on my 1985 model since they are the same horse power. Any help with this would be greatly appreciated.
How hard would it be to install electric start on a 1985 25HP johnson. Could you also please help by letting me know which parts I would need etc. Thank you for your help.
I have a 1985 Johnson 25HP. The throttle on the tiller arm is hard to hold in the wide open position feels like it wants to retrieve back to the low idle position for some reason. I have greased all the fittings and no relief. I noticed there is a phillips head screw on the underside of the...
I just bought a 1985 johnson 25 hp motor form a boat dealer. While at the boat dealership the motor started and pumped water beautifully. I got the motor home and hooked it up to my boat and into a barrel of water it started right up and pumped water then all of a sudden it stopped. I contact...
I have a carolina skiff J14 do I need a short shaft or long shaft motor. My boat at the rear where the motor mounts at the transom is 17 inches. Any help would be appreciated.
I have a 94 johnson 15hp that I just purchased and it is in the shop with a bad head gasket. What would cause the head gasket to go bad can anyone help. THanks
