Recent content by akcooper9

  1. A

    Water Leak Question

    I sprung a leak this year that I can't seem to track down on my Aplha 1 Gen 2. I've replaced the U Joint bellow and shift cable bellow along with the upper swivel shaft pin and seal (all of which was needed). I no longer have water up top or midway up etc. This leaves me to believe the leak is...
  2. A

    Captian's Chair Seat Bottom Repair

    When I bought the boat, both seat bottoms looked like the below picture. What are your suggestions in re-enforcing the area to re-attached the swivel?
  3. A

    20.5 Ft Bowrider Prop Choice

    Its everyone's favorite question...what prop do for my boat...haha Anyways, I have an 03 VIP Vixen XL 2096 (weight is right around 3500lbs with fuel) 20.5ft Bowrider with a 5.0 MPI and alpha 1 gen 2 with a Mercury Mirage 48-13702 21P prop. Boat flat out hauls the mail with GPS verified speed of...
  4. A

    Swim Platform Re-Hab

    I picked a used 2003 Runabout that when new had a factory swim platform installed. Its clearly obvious they forgot to install limiters on the out drive thus causing the damage in the pictures. The limiter were installed and for the last 10 years, the swim desk has looked like what you see in the...
See more
Top