Recent content by alboraso

I have a few questions. I have a small 1966 Johnson outboard motor which I tore out the old foam in the hood. What is the best material to replace that with? Also, is there somehwere that I can get decals to match the originals on that motor? Thanks

I am replacing a fuel pump. Do I need to use some kind of sealer on the gasket that attaches to the motor?

I have a 1966 Johnson 9.5 hp motor that needs a new fuel pump. I've seen several here on Iboats for sale that look similar to mine but I'm not sure which one I need. Thanks.

I have a 1966 - 9.5 hp Johnson motor. I took apart the fuel pump, somewhat by accident! Not having an owner's manual and not knowing too much about outboards, I'm a little lost as to how this goes back together. I was wondering if I can purchase a new fuel pump that is put together and not the...

I have an older trailer for my 13' Jon boat that I just purchased. I noticed that the bunks were not supporting the boat so I adjusted them and now the boat is resting on the bunks. The back of the boat clears the last two rollers by less than 1/4" but the front of the boat is still resting on...

I have a 1984 9.9hp 2 stroke Johnson. I know there are a lot of threads about Seafoam but it's hard to weed through all of them to get the information I need.I just purchased this motor & it probably has been sitting idle for several years. It seems to run fine & I just had the impeller...

I have a 1984 Johnson 9.9 outboard. What do I need to do a water flush besides putting it in a garbage can? Thanks

I have a 1984 Johnson 9.9 long shaft motor. I don't know much about outboards but I'm trying to sell it and several people that have come to look at it said that it has water pump issues. The first said that water should be streaming out really hard from the water port hole. It does stream out...