FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
this is a 1991 omc cobra 3.0 4 cyl. I saw the paint was pelling on the exhast pipe under the riser so i took the riser off and the flapper was gone i ran a camera threw (all clear) then i put the rubber hose on the riser when i looked at it well you all know how the exhaust inside flares out and...
I need some input i have a 1982 3.0 merc i/o turn the key and fires up next time you have to wind the fool out of it to get it to start it does this hot or cold i have 145+/- on all cyl. new starter plugs/wires dist.cap coil fuel pump,carb rebuilt (no change)oil pres is 40/45 its onlyhas...
Everybody thank you for helping me in the past .Now i would like to know about this exhaust shutter wile my riser is off ( 1991 3.0 cobra) i pulled the rubber off the tube and all I found was a little rod with no holes for screws or rivits does this mean my boat did not come with one this is the...
I have a 1991 3.0 cobra. It runs good comp is 160 +/- on all 4cyl getting water in #4 . i pumped 15psi into the head and block its still holding after 8hrs and when i crank it runs great for about 10min and then fouls the plug.Pull plug and water on #4 .Could it be the manifold or what ?
I have a 3.0 cobra and the model # 's are gone stiker is there no #'s i need a manifold i have the block #'s 14096613--341/89 made in mexico casting # on manifold is 986518 model and ser. # on transom in back of motor for out drive is 986028--t00280692 mine has no end caps only a90 that screws...
