alldodge's latest activity

  • alldodge
    alldodge replied to the thread 4.3gxi bad temp sensor?.
    Good point, have motor running
  • alldodge
    alldodge replied to the thread 4.3gxi bad temp sensor?.
    Motor of voltage for TPS looks good, MAP is a bit low, should be closer to 4.9 but 5V ref is a tad low Once started the MAP should be...
  • alldodge
    alldodge replied to the thread Rear water port near deck.
    My guess is the boat use to be in salt water and that is a fresh water flush port. It's probably missing a cap
  • alldodge
    alldodge replied to the thread Rear water port near deck.
    Welcome I have an idea but first, what boat is in pic? There should not be hot water coming out of it while running. It might be a...
  • alldodge
    alldodge replied to the thread 4.3gxi bad temp sensor?.
    Which other sensors have you swapped? Measure 5V reference voltage on the MAP or TPS What voltages does Techmate show for TPS and...
  • alldodge
    alldodge replied to the thread WOT RPM Low. MAG350 MPI B3.
    Scott, it's a Merc so most likely 43 psi, Volvo Penta is 50-60 FP can change a few psi, like 40 at idle and 43 or so at WOT What are...
  • alldodge
    alldodge replied to the thread 99 Volvo 5.0GL.
    3-8 is low pressure A VP high pressure pump is 50-60 psi
  • alldodge
    alldodge replied to the thread fuel leak from infloor tank.
    Welcome With it only happening when the bow is raised, look at the tank fittings and hoses You will have the main tank fill hose, tank...
  • alldodge
    alldodge replied to the thread 4.3gxi bad temp sensor?.
    That sounds like the IAC as Scott mentioned
  • alldodge
    alldodge replied to the thread 2006 5.7L Mag Overheating.
    Check the hose from the bell housing to the transom plate, might be collapsing
  • alldodge
    alldodge replied to the thread Throttle movement but no increase in engine rpms.
    Blades are thinner so less drag but as Scott mentioned I think your motor has lost some HP
  • alldodge
    alldodge replied to the thread MC-1 Drive Dog failure?.
    Your old motor is not a HP big boy so using your old gears does not concern me, but this is your money and not mine I would rebuild the...
  • alldodge
    alldodge replied to the thread MC-1 Drive Dog failure?.
    I'm not there but hide sight is always 20/20 If it was mine I would want to determine if a new SEI drive will fit but that's 2K The...
  • alldodge
    alldodge replied to the thread MC-1 Drive Dog failure?.
    Bummer That case is junk
  • alldodge
    alldodge replied to the thread 2001 5.7 GSI flooding.
    Welcome Looks like you need to reload your parts cannon What kind of testing have you done prior to replacing parts? Have you checked...
Show older items
Top