Current visitors

alldodge's latest activity

alldodge replied to the thread Bayliner contessa wont plane.

A lower ratio leg with higher pitch prop is better than the reverse Another example same Formula 27PC 530HP motor using a 1.82 ratio...

Tuesday at 1:21 PM
alldodge replied to the thread Engine backfiring through throttle body when trying to accelerate.

Unable to say exactly but controlled by the ECM. The contact width of the rotor and width on cap provides a certain amount of degrees

Tuesday at 1:17 PM
alldodge replied to the thread Bayliner contessa wont plane.

If the crane scale was accurate then the only thing left is you need more motor. The boat most often came with twin 225 of 260hp motors...

Tuesday at 12:05 PM
alldodge replied to the thread Engine backfiring through throttle body when trying to accelerate.

Back firing through intake is caused by spark happening at wrong time, intake valve not fully closed. It's suggested to keep a spare...

Tuesday at 10:25 AM
alldodge replied to the thread Engine backfiring through throttle body when trying to accelerate.

The caps on these motors may last a long time and others have a very short life. You can't look at one and see that it's bad. Search the...

Tuesday at 6:45 AM
alldodge replied to the thread Bayliner contessa wont plane.

I would suggest taking boat and having it weighted Boat spec says it's around 6K lb, so with gear and trailer its up around 10K...

Tuesday at 6:14 AM
alldodge replied to the thread Engine backfiring through throttle body when trying to accelerate.

Have you replaced the distributor cap and rotor? Are your Vac gauge readings in kPa?

Tuesday at 6:02 AM
alldodge reacted to jonnyfish's post in the thread 1976 Starcraft Mariner 21' Layout Changes? (v2) with Like.

Checking back in as the build has been underway and i just haven't made time to post any updates on the process. The Deck boards are now...

Tuesday at 5:28 AM
alldodge replied to the thread Installing Water Heater w/ closed loop 8.1 engine?.

Here is someone who did it Here is the thread...

Monday at 3:24 PM
alldodge replied to the thread Installing Water Heater w/ closed loop 8.1 engine?.

I had a Merc that feed the water heater from the block drain port going in and the water pump housing on return. I don't have a VP 5.7...

Monday at 3:17 PM
alldodge replied to the thread Installing Water Heater w/ closed loop 8.1 engine?.

There is no schematic and it's just 2 lines. One in and the other out.

Monday at 1:01 PM
alldodge replied to the thread 2004 Volvo Penta 5.0GL-E with SX-M outdrive leaking through exhaust into bilge.

We don't post links to manuals due to possible copy wright issues You can find some at manualslib You can find parts breakdown HERE
Monday at 5:51 AM
alldodge replied to the thread Power trim wiring.

Welcome Have a look at MaxRules for diagrams

Monday at 5:42 AM
alldodge replied to the thread Starter wire issue.

Many are installed this way because the Red wire terminal is not large enough to connect direct to starter post. In Merc documentation...

Monday at 5:37 AM
alldodge replied to the thread Dual battery or booster pack?.

That will work While not absolutely necessary if you add a Bat switch to connect House and Start Bat for use if Start Bat will not crank...

Monday at 5:25 AM

Show older items

Home
Members

Top

View All

View All

View All

View All

View All

View All

View All

View All

Boat Bimini Tops

Boat Covers

View All

View All

View All

View All

View All

View All

View All

alldodge's latest activity

Follow Us