Recent content by Alterd88

Took it for a test run last night and ran perfect!

It was the trigger thanks for all the input!!

I have to get a puller to take the flywheel off.

I found out where. Not sure what it is

That’s on top of the motor it’s supposed to go somewhere under the flywheel. From what I can tell it’s connected to the throttle.

Any idea where that piece connects to?

Any idea where this piece goes?

Morning I looked through threads but I have a question I’m working on my late fathers boat that we loved to fish with. But it’s been bogging down at take off. If I feather the gas I can get it WOT and let it fly. While replacing the impeller I noticed this. I was told it’s for timing but does...

I got a question for all. I haven't has any problems since my last post until Tuesday. It ran fine all day tubing. I kept it at 20 mph, it ran fine. Until, i took my 16 yr iold out and was bringing it up around 25 or higher. I noticed when i hit some waves it surged along with my fuel gauge. I...

I recently bought an 89 kayd 18ft deck boat, when i looked at it it started right up. Checked the oil no milky residue (head / or cracked block issue).Which was good. I took it out once to check it out it started but ran rough . I couldn't get it to stay running. Itook it home checked the water...

Can anyone tell me the torque specs for intake manifold, rocker arm, exhaust manifold,and cylinder head please.

Sorry posted this in the wrong area the first time. i have a mcm165 with sludge in oil throughout motor except in cylinders and coolant paths. going to reaplce head gasket set and have heads redone i.e. valves reseated and heasd checked. i did find a bad intake gasket. any suggestions

i have a mercruiser mcm 165 that has a sludge problem i have the upper half apart to find oily sludge in the valve cover the push rod valley also on the dip stick any sugesstions i just got a head gasket set and gettin ready to replace them. i found the sludge mainly on the intake side the...