Recent content by anthony1

  1. A

    Another Un happy carb adventure question

    Hey all. i have a 87 3.0 mercruiser 140. Rough idel very rough . I rebuilt the carb with a kit from Mikes carburator and it runs better, no corn gas in the tank and about 4 psi on the fuel pressure. The carb was running terriable at idle before rebuild. Now hears the problem, its ideling too...
  2. A

    Gas feeding problem... I think

    I inherited a 89 bayliner with a mercruiser 350 stern drive in it. So here is what i am into, boat was given to me as a literal basket case, im thinking great daddy daughter project. I figured all the wiring out as they ripped them out. Took out the GM distributor in it (should tell you what...
  3. A

    Quick wiring question

    have a boat that all the wires were cut out... i have attached the photo here in the post. I have most of the motor part figured out.. however .... i am not 100% sure what port number the wires for the ignition , safety , and voltmeter belong to... and the diagram is not a tellin... does...
  4. A

    boat scrap yards near me

    Does anyone know of some boat scrap yards near horry county SC ?
  5. A

    ignition question on my 5.7 serial number d376336

    So i get this boat and the wiring is a basket case , however i have figured most of it out. However there is the thunderbolt lv ignition system. The distributor cap on the boat has not a place for the coil, and the coil was missing but the clamp for the coil was attached to the boat. Here is...
  6. A

    Bayliner key question

    Hey ... i have a bayliner i am restoring. How do i get a key for the ignition?
  7. A

    Need Help identifying a remote control and a few questions

    Hey Gang..... i have to identify the following remote control (see photos below ) I also could use a few questions answered if possible. I have done a search The remote has 4 wires coming to it, and you are able to trim from two sets of buttons on the top of the handle (one on the right and one...
  8. A

    Need wiring diagrams for a bayliner i inherited

    Hey all i have inherited a 90 bayliner cuddy model 2252. It was given to me and has most all of the parts there. The owner swears that the motor runs but i will verify that as soon as i get the wiring diagrams Not so much the boat diagram i am a fairly good electrician so i can figure most...
  9. A

    Need help - Prop sizing and current low rpm's

    Hi Guys Heres the skinny - 28' catamaran. Twin 60hp merc's 4 stroke 2006 with the bigfoot. Problem - only 4100 on the wot for both motors, motors making a little oil, might be low rpm related or not I will determine that this week I hope. Current prop numbers on the prop( I have not...
See more
Top