Hi guys,
well this yr when removing my lower unit anode the bolt broke. anyone know if this bolt is accessible with the lower unit removed? I think it is. Alternatively i'm looking for another way to get a zinc on the lower unit. i was looking for a trim anode but then all seem to be...
Hello All,
I'm getting a fuel restriction alarm when going wide open. New water separator was installed and inline fuel filter on the motor. In addtion the fuel line to the primer under the deck was replaced this yr which is what is different.
I took the water separator out of the equation and...
Hi All,
I have a 96 50hp johnson and i'm having electrolysis issues. The small zincs that come on the unit don't seem to be doing much. I'm looking to add but don't these zincs need to be in the water to prevent the damage? I ask because the factory ones don't which i don't understand.
thanks...
Hi All,
I have a 98 225 evinrude and i'd like to add fuel filter/water separator. The motor already has the inline fuel filter on the powerhead. Is there any risk of fuel restriction or the water filter removing oil from the gas causing a lean condition and powerhead failure? I run pre-mix and...
Hi All,
Well we went to the Atlantic city air show yesterday(about 15 miles away). We were doing about 3800 rpms and at one point I sped up a little bit and heard a chirp from my warning system. So I backed down the throttle to about 3800 and everything seemed fine. It can not be oil because I...
Hello All, just purchased a 96 50hp johnson. The motor runs pretty good but seems to have a fuel issue or something. When on plain the motor will kind of speed up slow down speed up slow down. I believe this would be some how fuel related. The motor is vro injected but I have plugged that intake...
Hi all, I have a Grady White with a 225 evinrude. My steering cable recently broke and I have a couple of questions.
Can I put the new cable back in without removing the motor? The reason I ask is because we had to slightly slightly bend the old to get the right angle to remove. If I do this...
Hi All, I have an 84 35 hp Johnson and yesterday it started acting funny. I was cruising along at full throttle and the engine whacked out, jumped up like i hit something and stalled. No damage to the lower unit that I can see. She started rt up but will only go to about 1/2 throttle before she...
Hello all, quick question I'm hoping someone can answer. The lower unit has 2 shafts, 1 gear/throttle and 1 drive. This is kind of hard to put into words but here goes. The gear shaft comes down the motor and into the lower unit. At the bottom just before it goes into the lower unit it is...
Hi everyone, I've gotta 225 Evinrude that recently started having some problems. I just had to replace my power pack to get her running. Starts up good but seems to "kick" like it's missing spark or something. We got a test light and tested for spark which may have been escaping and it was good...
Hi guys, Found a 93 50hp johnson. Looks in great shape. Guy wants 1500, no controls. Seems like a decent deal from what I've found so far. Any thoughts????
Hi guys, Found a 93 50hp johnson. Looks in great shape. Guy wants 1500, no controls. Seems like a decent deal from what I've found so far. Any thoughts????
Hi guys, I'm looking for some websites for used outbaords. I'm also checking ebay and I've found a few wesbites but they want way to much money. Looking for 50-60hp for under $1000. T
Ok guys I'm reachin out to the wealth of knowledge on this forum. I want to install a windlass anchor winch on my boat. Only thing is I don't have the launching mechanism already installed on the bow. My question is do they make attachments for the bow to lay the anchor on and if so is anyone...
