Recent content by Antti84

  1. A

    VP 5,7 GSI starting problems(fuel pumps not active on crank)

    I could use some help with getting my volvo penta started. I am getting spark,I am getting fuel for the 1-2seconds when the fuel pumps are priming with some fuel. I have measured that the fuel pump connectors are getting 12V for the first two seconds,then it stops. So during crank it's not...
  2. A

    Faria RPM gauge not working

    Hi! When I tried to start my engine on my boat I noticed that the faria rpm gauge is not working( needle at zero) I have a hour gauge(digital),and that is working which indicates that it's getting 12v Any ideas where to troubleshoot? Thanks!
  3. A

    Shift cable on volvo penta sx-m

    Hi! I bought a boat earlier this year and just serviced my sx-m outdrive (new cylinders,hoses and bellows) Now when I hooked up everything together the shift cable is very stiff when I try to move the lever from Neutral to fwd.When I move it backwards,it moves freely as it should. Does these...
  4. A

    Replace Trim hoses on Volvo Penta SX-M Outdrive 1999

    I am in the process of replacing the Trim hoses on My SX-M Outdrive. The problem is that I have ordered the parts as below, but If I install them as on the exploded view, the STBD side hoses are not fitting properly (nearly kinked). 3853855 is installed up in the manifold and on top of the...
  5. A

    An Additional Volvo Steering Arm Removal Question

    In continuance of an older topic titled Volvo steering arm removal I need to get the gimbal ring off because I need to sandblast and paint it. I screwed the three screws off at the bottom, bought the 9/16" bolt and a big washer according to the descriptions above. What happened to me was that I...
  6. A

    Seakitchen removal

    I am planning to remove my seakitchen on my 1995 Excel. Removed the 4 screws under the seat but the seakitchen still wont come off. Are there any other screws or bolts than those four? Thanks in advance!
  7. A

    Excel 21 SL cuddy seakitchen removal

    I am planning to remove my seakitchen on my 1995 Excel. Removed the 4 screws under the seat but the seakitchen still wont come off. Are there any other screws or bolts than those four? Thanks in advance!
  8. A

    Does an inline six cylinder engine fit wellcraft Excel 21

    I was wondering if a straight six cylinder engine would fit my wellcraft Excel 21 SL. The engine is an Mercedes 300turbodiesel car engine that I am going to convert to marine use. Will it fit or will it be too tight? Anyone fitted six cylinder engines to a wellcraft Excel or similar boat
  9. A

    New ignition key to my Wellcraft

    I own an 1995 Wellcraft Excel 21 SL and I bought it as a project. Unfortunately the last owner lost his key to the ignition so I will need a new one. I saw that iboats had ignition keys for sale, can anyone tell me which of those fits my boat?
  10. A

    Need a complete windshield for my Wellcraft Excel 21 1995

    I am in need of a new windshield(walk thru) for my Wellcraft Excel daycruiser 21 from 1995. Right now both frames+windshield has been stolen from the boat and I bought it as it was. Never knew that the windshields were so expensive before I bought this project. Can anyone tell me where I could...
See more
Top