FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Re: 96 Glastron SSV 175 - floor / seat mounting repair?
I did bounce on the leg of the outdrive, no flex. I'll pull some bolts out when I get a chance and inspect to be sure. Here's a pic of the floor, like I said not much to see. I'm sure it needs a new floor, just not ready to get into that...
Re: 1996 3.0LX Mercruiser Thermostat & Housing question
FYI, in case anyone else goes through this, the original thermostat is much smaller diameter. The correct part # for the new housing is 807252-1 (Sierra #18-3551) the one that came with it is 807252-2 (160). I checked Napa but it was...
Hey guys, problem started with the temp gauge not working. The gauge itself checked out so I bought a new temp send sensor, installed it, overtightened it putting it in and cracked the housing. Before It started leaking too bad I ran the engine but the gauge didn't move. Not sure if I looked at...
Hey guys, just bought this boat last week. Took her out Sunday and found a few things I need to repair. The driver seat screws pulled out of the floor. Just wondering if I could use toggle bolts or something to re-install or is the fuel tank in this area? Don't want to drill into that. Looked in...
