Recent content by Arnold96

  1. A

    Kerr Lake Stripers

    2 things. Have the stipers made it back down past the Clarksville bridge yet? Has anyone heard anything about any parasites on the stripers? :eek:
  2. A

    Seastar helm seal leak

    I did the search and can not find the info on how to replace the seal on a Seastar Helm. Does anyone know how hard this is and how to do it step by step. I could not find it on their web site. :confused:
  3. A

    Fuel overflow vent

    I think I may be getting water in the tank through the overflow. Are these things supposed to have checkvalves or baffles to prevent splashes from going into the tank? I recently filled up after having been out that day and noticed that water was spitting out of the overflow as soon as I...
  4. A

    Yamaha warm start issue

    Sometimes when the engine is warm the engine will not start for a few minutes. I have replaced the fuel bulb, but have not had it out since. I replaced the bulb because it would go soft in a few minutes of sitting. It will always , but sometimes will not start. I have also noticed that at...
  5. A

    Steering leak

    I have a 96 Century 23' WA with a Yamaha 200 and the steering leaks. It had a small leak back at the engine where the steering rod comes out of the housing. Now it has developed a leak at the wheel where the wheel attaches to the pump. I can't find any info in the Clymer manual. How hard is...
  6. A

    Broiled fish.

    I have cooked freshly cleaned Bluefish this way with good results. On the grill I put tin foil, then the fish skin side down. I put paprika, a little butter, hint of lemon for about 15 mins. on low heat. Yum, Yum. Same recipe with Salmon. Yum, Yum. However, the same recipe with Spanish...
  7. A

    How long before it fouls?

    How long can you leave a boat in saltwater without treating the hull before stuff starts to grow on it??
  8. A

    Steering Oil

    See signature for type of boat. I have hydraulic steering on the boat. This afternoon it seemed like the steering was slipping when the motor was trimmed all the way down. When I got home I noticed a few drops of oil around the O ring where the shaft comes out next to the motor. There is an...
See more
Top