Recent content by Ash Lewis

  1. A

    Chrysler Trim & Tilt.

    When you top up the pump with the fluid. Does the system need to be bled?
  2. A

    swivel bracket

    I have a 105hp with the stern bolt corroded in the swivel bracket. I need to take the swivel bracket off. I have removed the kingpin cap and taken out all the bolts holding the leg cover. Is there a special technique or tool required to remove these items?
  3. A

    Evinrude 115hp Water in exhaust port

    I am looking at a used engine Evinrude 115hp (1995).The owner has said that the base gasket has failed and water has entered through the exhaust port into the bottom cylinder. Engine turns over freely and the compressions are all the same as this test Compressions are No1 120psi No2 120psi no3...
  4. A

    Johnson Copatability

    I have a 115hp Johnson Model 115TL79R, I have another motor an Evinrude 100hp Model 100293R. Are the power head and gear box compatable between models? Thanks
  5. A

    75hp fails under load

    G'Day I am a brand new member, in Australia. I am having troubles with my Chrysler 75hp 3 cyl outboard. Model 757HB ('75 - '79) Serial No. 16965. The motor will fire quite easily. However will stall under load. The carburettors have been removed jets cleaned and replaced. I believe it may be an...
  6. A

    Chrysler Magna Ignition

    G'Day I am a brand new member. I am having troubles with my Chrysler 75hp 3 cyl outboard. Model 757HB ('75 - '79) Serial No. 16965. The motor will fire quite easily. However will stall under load. The carburettors have been removed jets cleaned and replaced. I believe it may be an ignition...
See more
Top