FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
Here's my LMS 332c circuit board. I'm showing where the power source is on the lower right, and where I believe the first two ribbon cables that lead to the power switch on the front panel (upper left) are. Can anyone tell me how to disable the internal power switch and where? I want to install...
I've followed instructions in the manuals which indicates to install lower unit with gear housing in Neutral and I've made sure the lower unit is in Neutral but when I tighten up the bolts the upper shift shaft is pushed upward. Manual says to re-align shafts with light hammer taps using punch...
Seems to run great until after about 10minutes being warmed up. It starts to hesitate when you put the throttle down and progressively gets worse.
I replaced all fuel lines. Replace fuel pump gaskets, replaced one float that had one side full of fuel so thought that was it.
Seemed to run...
My engine starts and runs but does not idle very well. Will die often when putting in forward and especially reverse. Once up to speed seems to run well.
When I take lower spark plug out there always appears to be water droplets on the plug or condensation if you will. I've replaced Head...
Anyone happen to have the bolt torque specs for the following on my 1975 50hp Evinrude?
Head Bolts
Exhaust Cover Bolts
Exhaust Housing Bolts
Replacing all gaskets to try and finally fix a problem I've had with water in the cylinders..
I know I should purchase a manual but planning to sell...
I have a 1975 50hp Evinrude Model# 50573b.
I can't remove the powerhead or may also be called "exhaust housing". It's part #56 on this link: http://www.boats.net/parts/search/BRP/EVINRUDE/1975/50573B%201975/EXHAUST%20HOUSING/parts.html#
I've removed the engine block with powerhead from lower...
