Thank you. I checked all grounds. All are on so I'm gonna remove and clean all grounds on block to be sure. Can any other sensor shut down fuel injectors or ecu besides cam? Both pumps come on with key and it primes as it should.
Revs as long as you keep pumping. As soon as you stop it stops. But if injectors don't fire how does it start with me pumping fuel if it's fuel injected? Batteries atmre good and it cranks strong. Any specific wires I shout target ? Or any way to determine ecm is functional with out a scanner?
Ok I have spark and fuel pressure all the way to the injectors but they not pulsating at all. I have them all connected and raised the fuel rails to see and nothing come out as the not powering on. Whe. Tested injectors on rail with manually powering and the sprayed. Changed cam sensor, TPS...
Any trick to getting the shaft out? I took everything off and I can't get it to move or slide out. 😕 by the way these things suck. I shall never work on a penta again.
Hi, I have a 2000 Dt200. I was out in rough Seas I took a hard wave the motor went under and shut off I took it back out on the water after being towed drained all the water. After that we went out and about half an hour of trolling I had two fast and one slow check engine light which means tps...
its going beep beep beep beep and its starts as soon as i turn ignition on till after start and dont stop, i want to eliminate the oil injection and mix it my self. what should i do? or can i just mix the oil and fuel and cut the horn?
