FORUM RULES UPDATED - The forum rules have been updated to continue to provide a friendly and safe environment for our member community. Please take a moment to review the updated rules and our terms of use and privacy policy. Click here for Forum Rules which has links to the 'terms of use' and 'privacy policy'.
In Other News . . .
You will notice a few enchancements to the forums to make your experience better. These include: Email Notifications, Thread Previews, Thread Starter Notation, and Emoji Options on the 'Like' icon. . .
Additionally, the merchant portions of the website have been updated and are now operational. . . . Check out iBoats for all your boating gear.
I’m sure it is. They all run together. I’ll see if I can seperate it out. Wonder if a shielded cable would work. Kenwood doesn’t specify that out but it has to be a digital signal.
It works fine with the key on. Just not with the engine running.
Sorry I should have put engine info on there. It’s a Volvo Penta 3.0 stern drive.
It has to be an emf interference because everything works fine and then when the engine is running it just stops working. The radio still works fine but the remote doesn’t.
If I disconnect the control wire...
I have been trying to trouble shoot this for a while now. I have a kenwood marine media receiver. But my boat mounts it on the passenger side so I got a controller that fits into a guage hole and runs to the receiver via a single wire. I assume it’s the same as a steering wheel system in a car...
