Recent content by b-man

  1. B

    trim getting up on pad

    Hi, have a 16ft charger with a 125hp force and having a time getting boat up on pad. When I go to give it throttle the nose of boat seems to take longer to break over getting up on pad. Just put a new trim motor on it works okay, but seems like once it water motor don't raise up like it...
  2. B

    trim guage

    Hi have a 86 force 125 on boat, need a new trim/tilt guage old one is shot.Told that I have to get one for a force or a merc guage would also work, this correct? Where is the best place to get one? thanks
  3. B

    draining fuel

    Hi, Just wanting to know the easiest way to drain some fuel out of my tank, have a onboard fuel tank.Had some gas left in it since sept 08 think it might be a bad by now?Wanting to get ready for lake, did not want to chance it. Have a carb system, some told me to unhook the gas line going to...
  4. B

    trim motor help

    Hi I just changed my trim motor on a 86 125 hp Force, when I went to fill the unit with oil not sure what has happened? Put some fluid in, stopped hit the switch to raise and lower it finally started to work, guess there was air in lines. I stopped and put some fluid in to top off, and was...
  5. B

    kill switch question

    Hi I have a 85 Charger with a 86 Force 125, this boat is not equipped with a kill switch to my knowledge, is there a way to put one on and where can I purchase one? I fish touraments and it is required even if it is not, be nice to have incase of ?? thanks
  6. B

    changing lower gear lube on force 125hp

    Hi there, I getting to prep for winter and going to change my lower unit grease, I have a 86 Focre 125hp o/b. On this motor the drain plug is at bottom of unit much like a little screw. My question is the plugs, they are next to each other, unlike the top /bottom. I know I fill it thru the fill...
See more
Top