Recent content by barbwire44

  1. B

    Evinrude electrical trouble

    ok this is a 1973 85 v-4, last year I lost all spark, I got on here and was told pretty good chance it was the powerpack, (it only has 1 on this model). That was correct, new powerpack and it was back on the water, well the motor hasnt run 20 hours since then and at full throttle last week it...
  2. B

    Evinrude eating power packs??

    Ok well not really eating them but seems to have a problem. Last summer the first power pack quit, so I replaced it, ran the boat about 15 hours or so, just ate another power pack??? Orderd another one, but figured there has to be something causing this??? Any ideas?? thanks it is a 1973 v-4...
  3. B

    prop seal replacement

    Ok, I am going to replace the prp seals on my 115 evinrude, how do you do this, is it hard to do??? looks like form the parts diagram, pull the prop off pull the thrust washer and the 2 seals should slide out???? At least thats what I'm hopin for...LOL!!! and the seals go back to back? thanks
  4. B

    lower unit milky (115 Rude)

    Changed the gear oil at the beginning of the season, it was a tad milky colored, I thought well could be condensation from sitting over the winter. So I refilled with fresh gear lube, ran the boat two days, checked it this weekend and the oil is milky again??? I don't have water running out like...
  5. B

    Prop trading

    Don't know if the forum has a spot for it or not but I have a nice stainless evinrude prop that is to much for my boat it is a 12 X 20 pitch, I need a 13 X17 pitch. Is there any place on the web where people do this??? or should I just ebay mine and find a replacement???
  6. B

    Where to find a top like this?

    Re: Where to find a top like this?
  7. B

    Where to find a top like this?

    I have this same boat with an outboard and would like to find a top like this for mine, anybody recognize the manufacturer of this one..?
  8. B

    115 Tachometer help

    Installed a new to me 115 evinrude 1981 model, well somebody at some point in time cut the grey signal wire from the wiring harness. So I have to run my own tach wire from the engine to the tachometer. I looked through some old posts and it sounds like any of the yellow wires from the stator...
  9. B

    Need help with 1998 PCM 351

    The boat is a 1998 air nautique, it has the ford 351 PCM fule injected engine, the intake is cracked in a passage that can't be fixed. PCM does not carry this intake anymore, My question is where can I get one??? and the other question is, is this a standard intake from FORD???? thanx
  10. B

    Need Bilge with inlet hose??

    I have a hydra sports x-270 and need a bilge pump with an inlet hose, I can't get a regular bilge pump into the bottom of the boat. The bilge pump that was in it was a livewell pump with a hose attached to the plastic fitting that would normally go thru the hull. But it does not create enough...
  11. B

    water pump baseplate sealer???

    I just recently installed a new water pump kit, on a 115 rude, My manual showed one set-up with sealant applied to the base plate of the pump housing, and another set-up without????? which one is right, my kit had a gasket so I assumed I needed no sealer and now have a weak stream, is this the...
  12. B

    pee hole not peeing??

    Ordered a water pump and it should be in this week, but is there anything else that would cause this?? It is an 81, evinrude 115. Has sat for a year or so before I bought it, fires right up but with the muffs on it only drips water out the peehole. Like I said I ordered a water pump kit, but...
  13. B

    How much difference 85 vs. 115

    Curiosity is killing me but I am currently running a 1973 evinrude 85 on my 17' sunbird, I recently purchased a 1981 evinrude 115 with tilt & trim. How much of a difference in performance am I going to see???? it's 30 hp difference and the tilt and trim will be a new addition, had people tell me...
  14. B

    81 evinrude 115 shift shaft ????'s

    I am going to tackle my first water pump change on this 115 rude and have a manual and it looks pretty simple , other than the shift shaft disconnect, the shaft is pretty much in the middle below the powerhead and I don''t know hot to really get to it to disconnect it to remove the lower, any...
  15. B

    Need to paint boat from rub rail down???

    Bought a used rental ski boat a sunbird and it has scratches and chips allover the boat from the rubber rail down, my plan was to fill in all the cracks and scratches with 3m marine filler and commence to painting, bu thave no idea what is the best type of paint to use for an inexperienced...
See more
Top