I just replaced the starter solenoid for the 3rd time in 2 years. Bought originally from NAPA, who sells marine parts ( have bought impellors from them). Their part numbers are the same as Sierra Marine, so I am assuming that their part is the same manufactured part as Sierra. Can anyone verify...
I have always heard that when coming off the water for the day, to unplug fuel line to engine and continue to run engine until it quits, thus draining the carb bowls to keep fuel from sitting in bowls for extended period.
I acquired a 1992 Evindurde 115 hp ( crossflow 4 cylinder ) which has...
Just replaced burned up impellor, and before reinstalling the gearcase assembly, I would like to backflush with water. I have back flushed a 40 hp before by removing thermostat and forcing water thru at this point. I now would like to back flush 1992 evinrude 115 hp 90 degree crossflow with...
Trying to adjust for correct timing per manual I have, but doesn't say what timing should be at idle ( On muffs in gear at about 1,000 rpm ). Should it be at "0" degrees ( TDC) with the two throttle plates in closed position? The manual says at the moment the throttle plates start to open the...
Engine starts and runs well, when first unloading boat at lake. Will run wide open for maybe 15 minutes to fishing hole. When ready to restart and go to another area of fishing, motor starts and runs well wide open for about 5 minutes, then it just shuts down. It will restart, but will only run...
