I have a Nissan NS25C3 (2000) and converting to a remote steering. I have purchased a Nissan control box with an eight pin harness attached. What parts do I need to connect this harness to the motor electrical system, etc.
My motor is cutting out on me a few seconds after I put it in gear and give it gas. The bulb stays hard and it idles fine when its in neutral. I checked the fuse and all the electrical seems fine. I've added HEET to my tank but have not been back to the lake to test if water is in the tank...
There seems to be so much torx on the handle that it unpleasant on the wrist. What can I remove or do to eliminate this from coiling back. I have a breakdown of the tiller handle with part numbers if you can give me one. I do use the lanyard on my wrist when I go out for safety.
I bought a 2000 Nissan (NS25C3) in July and decided to check and clean the carb. While doing so I noticed that there wasn't a gasket between the carb and the inlet reed valve. My question is can I buy gasket material from a auto parts store or should I go tho the Nissan dealer and order the...
I have a 14' Nova Jon with a 25 HP Nissan 2 Stroke and my question is what is the best overall prop to use if your going to buy a new one. I don't know what RPMs I'm running (no tach) but my speed is about 24-26 mph according to my gps. Any suggestions. I beleive the manual calls for a
10 x...
My 25HP motor is losing power as the day goes on. What could be causing this? Just had a water pump installed and is doesn't seam to be peeing good as it should also. What could be stopping it up?
I bought a 25 hp nissan motor on a jon boat a couple of weeks ago, tried it out, ran fine. Week after took to the lake would not fire at all. What could be something I could check with a light tester? It's a electric start tiller handle. When I press the starter button no fire. Is there a...
