Just bought a used prop for by cobra SX outdrive. Went to install it and it would not slide far enough onto the shaft to get the splined washer onto the splines. Should the smaller part of the thrust washer fit into the center portion of the prop? On the new prop the hub is flush with the...
I have posted previously about problems with '96 5.0l EFI volvo penta. Ended up it was a detonated piston. In the process of having engine replaced. My question is about the knock sensor. If the knock sensor is working will it always prevent the pre-ignition? When you feel the timing being...
Looking at a 2001 200LX with a 5.0L Mercruiser and an Alpha 1 outdrive. I am not familiar with the mercruiser. It appears to be carburated instead of fuel injected. What are the opinions on these engine and outdrive?
Thanks!
I have a 96 Four Winns 200 Horizon with Volvo 5.0 fuel injected. Had it out for about an hour at high speed. It began to lose power and when I throttled down it died. It restarted after a couple of tries but was running rough. I thought it may be low/out of gas so I headed to the marina to...
I have a new-to-me Four Winns 200 Horizon with the following:
Engine mod - 50FAPNCA, SER # T01290298
Transon *** mod # - 3868413, SER # T00367816
Drive Unit mod # - 3868388, SER # T00802946
5.0l fuel injected
It runs great most of the time but it will occasionally loss power at wide open...
I am a first time boat owner. Just bought a '96 Four Winns 200 Horizon and have a couple of questions:
1. The trim indicator does not work. Where do i start?
2. Engine temp gauge seems to be sporadic. It runs around 120 even after running a while at higher rpm's. It will climb to 150...
Just bought a '96 200. Was trying to download the engine manual from the volvo site. The engine is the 5.0 w/ fuel injection w/ Cobra sx outdrive. All of the 5.0 fuel injected manuals are for the dual prop. Any ideas?
Thanks!
I have just bought a '97 200 Horizon (my first boat) that came with a Mastercraft trailer. Some of the initial observations are that it sits to far forward and the bow stop needs to be moved back away from the winch. It also appears to sit to close to the fenders (low on the trailer). Any...