Exact same boat and exact same issue. Glad to hear the dealer stepped up. I'm going to take mine in and forward a link to this thread to quell any potential "looks like abuse" statements.
Looking for some guidance. I have a 2020 Monterrey with a Mercruiser 4.5. Looking for a transom mount remote trim switch. I see there is a factory option, but wanted to see if there was something people here recommend that is not as bulky.
Thanks in advance for any suggestions.
Re: Upholstery Refurbishing with SEM products Marine Vinyl Coat
Stuff works great. Clean very well with the SEM soap and a scotch pad. Make sure you apply the vinyl prep liberally as its key to bonding the dye. It will cause the vinyl to distort temporarily, but it snaps back tight after you...
All,
I get several questions a week in my inbox in regards to using Coosa board for decking and Nidabond for stringers as I went the total composite replacement route. Probably the most common question I get is in regards to pricing and availability, and whether or not it is "worth it" (it was...
Re: My $17 Harbor Freight Tarp/Boat Cover
I learned my lesson with these type tarps and will never use them again. When they begin to break down, small pieces of the tarp will end up on your vinyl seats. This breaks down even futher into basic PVC chemicals, and you get permanent purple spots...
Take a look at this project:
http://cgi.ebay.com/ebaymotors/81-Egg-Harbor-Flybridge-Sedan-36-Cabin-Cruiser-MD-/360390801765?pt=Power_Motorboats&hash=item53e8f73965#v4-44
Ben
Yes my drain plug is in. Just suddenly started taking on water. It's a 1995 5.0 with SX outdrive. Any thoughts are welcome as I'm at the dock with no trailer and relying on the bilge pump.
Ben
At least that is my best car analogy. Boat was running great, not a single problem. Leave it for a week then starts on the first turn of the key. I put it in gear and it feels different. As i rev the engine, it feels like the clutch is slipping or the gear is not fully engaged. This happens...
Well,
After sponging a lot of knowledge from this forum I decided to tackle the restoration of my 1995 Larson 214 LXi. I have had the boat since new. This will be the second floor replacement for the boat. I know its too young to require another floor, but when it was just a few years old...
Decided to redo the vinyl while waiting for my deck composites. Had a local shop paint match some vinyl dye to the factory colors. My interior is 3 colors, so picked up a quart of each (minimum order). Used a disposable Preval sprayer ($4) to apply - no mixing or thinning. Never used this...
I see that Seacast is used for stringer repair, but what about the competing Nidacore product? Their website indicates Nidabond's use for transom repair, but no mention of stringer repair.
Thanks,
Ben
Going to be replacing the deck on my 1995 Larson 214 LXi here in the next month. Done a lot of research here - what a wealth of information! Anyway, while all the fiberglass and resin work looks like good fun, I was wondering if anyone has considered or used plastic composite plywood for their...
Hello All,
Long time lurker, first time poster.
I am going to replace the deck in 1995 Larson this fall. Prior to starting that project, I have a nagging issue I hope someone can help me with. In my ignorence, I stored my boat under a blue PVC tarp one year. Apparently the PVC broke down in...
