It's a1998 dt 200 and I have no spark too any cylinders it turns over fine I have eclectic fuel pump working correctly. And power trim is working fine I'm looking for causes of interrupting the spark I have ordered a manual but am trying too familiarise myself with potential causes that will...
#2
Today, 08:08 PM
Should the kill switch. Neutral switch . Oil solenoid and low oil reset circuits all be closed circuit for engine too have a spark and I should have continuity in both wires of each switch ??! Thanks
So I have the engine all wired up I have trim and tilt working fuel pump working and an intermittent bleep from controls the engine turns over but I have no spark too any plugs where do I go next too check wiring faults what could prevent a spark and how do I test and eliminate
Hi there does anyone have a link for a manual. I am rebuilding my mariner 200 hp v6 two stroke offshore serial number 9518131 not sure of year thanks in advance rob
whilst giving my mercury 100hp 2 stroke 4 cylinder a severe service and maintenance check i removed gearbox to replace impeller and found the water pump bolts were corroded and were gonna break off after soaking them and moving them forward and back I eventually removed all six with no problems...
I have just purchased a mercury 200hp outboard as a non runner project the condition is like new but has had piston failure and has marked the bore I have a replacement piston and rod but have been told that I can replace the liner rather than re bore or hone is this correct can I buy a liner...
Hi there I am iin need of wiring diagrams for a 75hp 3 cylinder mariner outboard serial number 9530342.
I was sent a link to a compressed manual which was very helpful but the only wiring diagram showed an engine with no low oil module wiring on it I have a low oil unit with.
Dark blue...
I have my 1988 3 cylinder 75hp engine in bits just put crank and pistons back in but am now stuck as I don't know torque settings for con rods and head too block bolt settings
many thanks
I have a 1998 Mercruiser 5.0 bravo engine that I am fitting in my 18ft regal speedboat that originally had a 3.0 v6 engine and drive I have the engine and have been offered a brand new never fitted transom assembly and gimble with rams it's a mercruiser alpha one gen 2 transom serial...
Hi there I'm new too forum and am in need of advice I have a mercruiser engine listed above it is complete and was running until I removed it from boat hull too fit y pipe as original owner had thru hull exhausts. But whilst engine was out of boat the goats in the field have chewed. The harness...
