Having trouble getting to WOT with my Mariner. This year for some reason I cannot get the rpms above 3000 in gear under load but yet at the dock in neutral I can move the idle lever way up and get the engine to go wot over 5000. Is this an engine problem or a linkage problem with my remote...
Having trouble getting to WOT with my Mariner. This year for some reason I cannot get the rpms above 3000 in gear under load but yet at the dock in neutral I can move the idle lever way up and get the engine to go wot over 5000. Is this an engine problem or a linkage problem with my remote...
I have a 1993 Mariner 90HP that I been using for 4 years without problem.
Upon trying to find out why there is no warning horn signal upon starting, I found out that a previous owner had disconnected the horn in the shifter.
I then reconnected and started the motor, the warning horn turned on...
I have a 90 HP (1993) Mariner.
Since the boat went in the water the engine has been running irregular. That is the rpms are up or down varying 200 rpm. In one minute it will change rpms back and forth several times without touching the throttle. But the motor never stalls and always starts...
My speedometer on my 90 HP mariner is not working. I followed the tube back to the motor and no kinks. It goes into a fitting screwed into the lower unit. What should I look at next?
Just put my deck boat into the water and noticed that the tach and fuel guages do not work. The speedo works fine. I checked the fuses and they are OK. Don't see any loose wires inside the helm. What do I do next?
Got a FG hurricane deck boat. The port side docking cleat is broken and needs replacing. Trouble is the hatch to the bilge is on the starboard side and the bilge is not big enough to get inside. My arm is not long enough to reach inside the hatch and reach to the port side. How does one...
Bought my boat used last summer and the previous owner did not know anything about the fuel/water separator(filter) device. It has a clear section on the bottom with a drain on it. I know its purpose is to remove water from the fuel but how often do I drain off the water that collects in the...
I've got a 1993 remote control.
When using the Fast Idle Lever at first start, the lever does not move easily and seems to stay in a 2 o'clock position and go no farther. Upon starting the RPMs are low then jump up to high rpms all of a sudden.
Question: How does the "Fast Idle Lever" accuate...
